Calibration XY gone wrong

[Nicko_Airbus 2]

Hello friends, I have the ultimaker S5 Pro Bundle and I had the problems you can see in the photo below. Anyone can tell me what happened ?

 

 

 

 

 

As you can see, I have too much of the black material in one corner and for the support material, The material didn't stick to the plate... maybe it's because I didn't add glue on my bed.

 

In the second photo you can see that the materail stayed attached to the nozzle. Is that normal ?

 

[Smithy 1,145]

1 hour ago, Nicko_Airbus said:

maybe it's because I didn't add glue on my bed.

Short answer - yes it is the reason.

[Smithy 1,145]

Best is to apply some glue on the glass and then distribute it with a wet tissue. Then you get a thin even layer of glue on the whole glass which gives a good adhesion.