Issue with Cura's gcode not working with octoprint?

[RunLoganRun 1]

This occurred all of a sudden, I'm getting an "internal server error" from Cura, when trying to upload gcode, it also fails when I try to upload a saved file to octoprint directly, so it doesn't seem to be an issue with Cura communicating with the server, and a test with same stl's sliced in slicer uploads/prints fine. The only change is a switch to a larger nozzle, but the problem doesn't seem to be the printer or octoprint, as both are functioning normally.

 

I have a feeling it's something in Cura's configuration, but can't figure it out. If anyone has any advice, that would great.

[nallath 1,123]

Internal server error is generally used for when the server crashed during the handling of the request. It could be that the g-code does something to trigger it, but I'd say that the issue primarily is with the server.

 

[ahoeben 1,965]

The octoprint logs should include details about the server errors. If you post a link to them, so I can download them and have a look, perhaps we can see what is going on.

[RunLoganRun 1]

On 2/11/2021 at 3:40 PM, ahoeben said:

The octoprint logs should include details about the server errors. If you post a link to them, so I can download them and have a look, perhaps we can see what is going on.

 

It seems Cura wasn't allowed to put files in the upload folder. I changed the permissions, which seems to have resolved it.

 

It's very strange, as it happen spontaneously, and only affected the gcode files made in Cura.