There is a one layer gap between support interface and next model layer

[Rivanov 0]

I tried to improve the first layer above the support. I found an interface setting in the support section of the settings. There is a gap between the top support interface layer and the next model layer. I cannot find a solution to control this gap. I want to be less than one layer, for example, to be 0.1mm. There is the attached shot of my problem.

Would you help me?

[fvrmr 73]

Hi @Rivanov try changing the support roof line distance to 0.1 mm.

Let me know if that works for you!

[gr5 2,181]

You can set the gap to anything you want but I think it will be moved to the nearest layer.  I don't think you can do support on in-between layers without changing the vertical resolution (e.g. .06 layer height).