Cura 4.9.1 profiles?

[GNK 0]

Hi there.

I recently upgraded to Cura 4.9.1.

Using a AA0.4 and Green Tough PLA, I see only 1 profile (Fast 0.2mm). 

There are no other profiles available or ability to change to any other Default, Visual, Engineering etc. 

Why am I stuck at 0.2mm?

Thanks in advance for any assistance.

Greg

 

  

 

[nallath 1,123]

What do you have loaded in your second extruder? Try disabling it. The profiles you see there are formed from what both extruders support.

[GNK 0]

Thanks for the reply. 

As you can see, I've unchecked the box for Support. Does this not disable the second extruder? 

Greg

[gr5 2,205]

no.  Go into PREPARE mode (as opposed to PREVIEW).  Just below the bar with PREVIEW is a bar that shows your extruders and materials.  Click on either extruder (doesn't matter which) and it pops up a control with 2 tabs.  Choose the tab for the extruder to disable and uncheck it.  This is the same place where you can choose filament type/color/size.