Ultimaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.
They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access.
Ready? Register your product here in just 60 seconds.
Recommended Posts
ManAtArms 33
Wo hast du due Struktur geblockt? Am Boden oder am Deckel?
Du musst die gesamte rote Fläche blockieren die keine Stütze haben soll, wenn da auch nur ein Stückchen frei ist, funktionierts nicht.
Edited by ACCSiskoLink to post
Share on other sites
zerspaner_gerd 348
Hallo,
Falls ich das richtig verstehe muss der Blocker bis nach oben gezogen werden
Dann Funktioniert es nach meiner Meinung.
Ich persönlich mache es immer anders herum und zeichne mir ein wo support hinsoll und nicht wo es blockiert werden soll.
Bei manchen Teilen will ja Cura überroll ein bisschen Support platzieren, um da dann alles zu blockieren finde ich es andersherum einfacher
P.S.: Daumen Hoch 👍 das gleich ein Cura Projekt mit dabei ist
Gruß
Edited by zerspaner_gerdLink to post
Share on other sites
RaphaelOst 7
Jetzt hat es funktioniert, vielen Dank @ACCSisko @zerspaner_gerd
Link to post
Share on other sites