UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
ManAtArms 59
Wo hast du due Struktur geblockt? Am Boden oder am Deckel?
Du musst die gesamte rote Fläche blockieren die keine Stütze haben soll, wenn da auch nur ein Stückchen frei ist, funktionierts nicht.
Edited by ACCSiskoLink to post
Share on other sites
zerspaner_gerd 383
Hallo,
Falls ich das richtig verstehe muss der Blocker bis nach oben gezogen werden
Dann Funktioniert es nach meiner Meinung.
Ich persönlich mache es immer anders herum und zeichne mir ein wo support hinsoll und nicht wo es blockiert werden soll.
Bei manchen Teilen will ja Cura überroll ein bisschen Support platzieren, um da dann alles zu blockieren finde ich es andersherum einfacher
P.S.: Daumen Hoch 👍 das gleich ein Cura Projekt mit dabei ist
Gruß
Edited by zerspaner_gerdLink to post
Share on other sites
RaphaelOst 8
Jetzt hat es funktioniert, vielen Dank @ACCSisko @zerspaner_gerd
Link to post
Share on other sites