Infill showing through print

[shadowwolf2000 0]

Hi I have a bigtreetech biqu b1 and have been printing and have noticed I could see the infill through walls. Any solutions?

[nallath 1,123]

Can you also feel the infill through the walls or is it just a visual effect?

 

[shadowwolf2000 0]

It’s just a visual effect

[shadowwolf2000 0]

16 minutes ago, nallath said:

Can you also feel the infill through the walls or is it just a visual effect?

 

It’s just a visual effect

[nallath 1,123]

in that case Ithink your only option is to increase the number of walls

[shadowwolf2000 0]

42 minutes ago, nallath said:

in that case Ithink your only option is to increase the number of walls

Ok but I already have a wall thick mess of 1.6 and have 4 walls

 

43 minutes ago, nallath said:

in that case Ithink your only option is to increase the number of walls

 

[Smithy 1,144]

It also depends on the kind of material/filament you use. Some brands are a bit translucent and then you see more infill. As nallath said, increase the walls and you should be fine.

[shadowwolf2000 0]

3 minutes ago, Smithy said:

It also depends on the kind of material/filament you use. Some brands are a bit translucent and then you see more infill. As nallath said, increase the walls and you should be fine.

Ok thank you