Closed Body Support Problem

[Protheus 0]

Hi,

 

i have a huge problem with a (almost) closed body print and its support.

I want to print a case for my Zigbee Lan Gateway (attached). The walls are printed really good but as it gets to the support the whole print it getting a chaos. The printer tried to print the support in the air (about 1mm from the ground) but i set the "Support Z Distance to 0.2 mm.

 

I'm not printing that much, but till now the supports where printed ok. So i have no clue what's the problem.

 

I tried 5 prints with a little different settings and changed to a new nozzle. I leveled the printer (Artillery X1) 3 times but the result was every time the same.

I attached the whole profile.

 

Does anyone have a hint?

 

Best Regards.

Protheus

Body by Alex.F.stl PETG (Geetech) Cura Profile.curaprofile

[ahoeben 1,955]

Please save a project using File -> Save project... That way we know exactly what settings you use, what printer, etc. Unfortunately there is little to nothing I can tell from the low quality photo you attached.

[UlrichC-DE 109]

The project file would be really helpful.

Based on the STL, I would print the UpSideDown without any support.

Attached the rotated STL

921555081_BodybyAlex.F.stl