UM S5 stopping during 3d printing BASF CF15 filament.

[drkhurram 0]

I am printing parts using the BASF PAHT CF15 filament and noticed that UMS5 stopped with error message. Another thing that I noticed that the filament is getting distorted while printing. Does anyone had experienced this problem with CF15 filament?

[UlrichC-DE 109]

Hello

I do not know these problems with it.

I always take into account that PAHT CF15 absorbs moisture very quickly and a lot.

If you do not print this dry at 10% material moisture, virtually anything can happen.

The material then boils in the nozzle. It also pops now and then and the prints look like tar lumps.

Is your material dried?

Many greetings

[rafael_martines 0]

I´m suffering from the exact same thing here. Did you find any solution for your problem @drkhurram? I have to go to printer every two hours to cut the twisted filament and restart the print. 

[alnavasa 5]

I was planning on getting this material for the S5, as the hardest and strongest material to print, but, Reading this is pushing me back, what are your outcomes to the problem?