thanks! yup i managed to install the update after unplugging the air manager (at the top connector, not the bottom no idea why that should make a difference). i'm still getting the air manager error when I start printing, so I guess it has to be a hardware issue...
Edited by echongI'm also getting this problem, its very frustrating, i have taken the airmanager to bits and it can be only one of 2 things, 1-PCB 2-The fan itself. Both of these look completely fine to me and they are less than 2 years old, Looking at the fan makers website they guarantee their fans for 6 years... is Ultimaker going to help its customers here?
I currently have my fan uninstalled from the machine and control screen.
Recommended Posts
gr5 2,224
I don't have an air manager but I'm 90% sure you can just disconnect it (and optionally the material station), reboot and then install the update. After the update seems good you could optionally reconnect the hardware and reboot.
Link to post
Share on other sites