I don't know why I consistently forget to attach the code.
Why do the analyser move the PLA towers position (t1) ??
When looking at the gcode analyser, the last PLA tower (t2) is printed with 50% fan speed.
But I'm not sure the fan is the problem. Because again if this was the case. Then it should only be (t2) that was affected and not gradually get worse from the first (t6) to the last (t2) . I would say that t3 is almost as bad. and that is printed at 100% fan.
Recommended Posts
Top Posters In This Topic
32
24
3
Popular Days
May 2
5
Apr 4
5
Apr 27
5
Apr 29
4
Top Posters In This Topic
gr5 32 posts
JD-Art 24 posts
GregValiant 3 posts
Popular Days
May 2 2022
5 posts
Apr 4 2022
5 posts
Apr 27 2022
5 posts
Apr 29 2022
4 posts
Popular Posts
JD-Art
okay that was a lot of posted i'll see if i can get all the comments correct 😉 I know about the support expansion and most the times i also print with it. but for this test it was
Posted Images
gr5 2,235
Could you please provide the gcode for this 6 tower print so I can understand the order of things better?
You are saying it prints the right most tower first?
And the problem gets worse over time and then after printing the PVA it gets better again?
Doesn't that imply something to do with the fan? I assume he fan is at 50% for the left most tower. For the pva. I'd like to see the gcode though.
- George
Link to post
Share on other sites