Help Infill lines on outer walls (?)

[AfroPsycho 1]

There is strange lines on all of the side faces 

I guess it is caused by infill overlap I have tested it from 0 to 100 it is visible every time ( mostly on %100 ) 

when I test it with no infill there is no lines 

I have changed my motherboard and drivers 

but this problem was before I have changed electronics 

there is no ringing / ghosting / echo I have tuned acceleration and jerk 

I have checked belt tensions

also I was using marlin 1.0.x with my old motherboard now I have compiled marlin 2.0.x from scratch for SKR 2.0 Rev B

 

How am I going to get rid of this 

 

%0

%25

 

%50

 

%100

 

no infill

Edited March 28, 2022 by AfroPsycho
Typos

[gr5 2,194]

You have lots of fixes.  You could just do thicker outerwalls.  That will have the infill far enough from the outer walls that you can't see the pattern.  Or you can change the order - print the outer walls first by checking the cura parameter: outer before inner walls

 

Although doesn't it print the infill after all the walls?  I forget.  Anyway doing outer walls first should help a lot.

[AfroPsycho 1]

On 3/28/2022 at 7:45 PM, gr5 said:

You have lots of fixes.  You could just do thicker outerwalls.  That will have the infill far enough from the outer walls that you can't see the pattern.  Or you can change the order - print the outer walls first by checking the cura parameter: outer before inner walls

 

Although doesn't it print the infill after all the walls?  I forget.  Anyway doing outer walls first should help a lot.

I use 2 walls I think it is default in cura and I really don’t want to add another wall and waste more time or filament with it 

Anyway I have tried it before and it was still visible with three walls 

I will check walls swttings and update here about it