-
Our picks
-
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications-
-
- 3 replies
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Picked By
MariMakes, -
-
UltiMaker Cura 5.7 stable released
ArunC posted a topic in UltiMaker Cura,
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
-
-
- 26 replies
Picked By
MariMakes, -
-
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Recommended Posts
gr5 2,194
If it's still spinning then power cycle the printer. Go to the part where you can control the cores separately and heat the problem core to normal printing temperatures (200C for PLA). Remove the bowden on top of the print head (remove the clip, then press down on the outer collet while pulling up on the bowden.
Try pulling the filament upwards out of the print core. If it is stuck then wait for it to heat up.
Once the filament is out of the core try lifting the lever on the feeder (it's very strong - lift hard) and pull the filament out of the feeder downwards.
Link to post
Share on other sites