Hi, I am interested in knowing how you avoid levelling errors, due to magnetic interference with the capacitive sensor ? Did you manage to deactivate the auto-levelling ?
Thanks
Hi, I am interested in knowing how you avoid levelling errors, due to magnetic interference with the capacitive sensor ? Did you manage to deactivate the auto-levelling ?
Thanks
2 hours ago, Fablab_Descartes said:Hi, I am interested in knowing how you avoid levelling errors, due to magnetic interference with the capacitive sensor ? Did you manage to deactivate the auto-levelling ?
Thanks
I am using the Wham Bam Bed System on 7 Ultimaker S5's. We have not encountered any issues with leveling.
The only things we have learned using these for over a year is that it is important to review the Technical Data Sheet on materials. We learned that Ultimaker ABS can damage the surface so we use glue stick on those prints. It works very nicely. The support from WB is very good too, whenever my team has had questions about materials using the surface.
Yeah thanks for helping me out on youtube with the leveling matter.
funny you mention this about ABS because that happened to me the first print.
leveled the bed to the point the calibration card is just not touching it.
this in combination with magigoo works great.
PETG for that matter sticks perfectly without glue and comes of superclean.
6 hours ago, MOTO said:Yeah thanks for helping me out on youtube with the leveling matter.
funny you mention this about ABS because that happened to me the first print.
leveled the bed to the point the calibration card is just not touching it.
this in combination with magigoo works great.
PETG for that matter sticks perfectly without glue and comes of superclean.
You're welcome! It's a really great surface for printing.
I just did a bunch of ABS prints here and I just run the surface under hot water to get the glue stick off. A few wipes and its ready to go for the next print.
Recommended Posts
kayakbabe 12
Ive been using hte wham bam flexible bed with my s5 for almost a year. it is fantastic. I totally agree with you.
Link to post
Share on other sites
MOTO 2
Purchased this system a while ago but haven't got to installing it yet. Mostly because i read of people where the leveling process pinges into the bed.
So you use the manual bed leveling process i assume, since you talk about using alot of the spring travel.
(which still is an issue i guess?)
or do you just screw it down so the system is about 14mm and let the auto level do its work?
Link to post
Share on other sites