UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Is it possible you are slicing for the S3 but printing on the S5 printer?
I don't know if the nominal offset between the nozzles is controlled by the printer itself or by cura. I'm thinking maybe it's cura and the problem is with your machine settings somehow?
It looks like the value is here - 22mm check this for your machine settings (must go into PREPARE mode in cura, then click your printer dropdown and "manage printers"
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
Recommended Posts
gr5 2,189
Is it possible you are slicing for the S3 but printing on the S5 printer?
I don't know if the nominal offset between the nozzles is controlled by the printer itself or by cura. I'm thinking maybe it's cura and the problem is with your machine settings somehow?
It looks like the value is here - 22mm check this for your machine settings (must go into PREPARE mode in cura, then click your printer dropdown and "manage printers"
Link to post
Share on other sites