I think it cuts power and for most S5 printers, the weight of the bed is enough for it to coast down.
What do you want it to do if the print is almost as tall as the whole space?
I think the only fix for this would be to alter the firmware. The firmware in question is in Python and is all visible, comments and all, on the S5. If you are a programmer and know a little linux and a little python it's not so hard to figure out all the code.
Recommended Posts
Dustin 160
For which model UltiMaker?
Link to post
Share on other sites
Carlzberg 0
Its S5
Link to post
Share on other sites