Hi @Leggy,
Greg is right, your model is somehow skewed, -and this happen to any of us sometimes.
When you install into another slicer it's approaching the right way "always"..
So, turn your view into the underside of your build place then you can see that the model is not touching all around as is should. If you also look around at the low bed level, turning your object or more correctly your viewing point -you'll see this opening that's making this happen.
Thanks
Torgeir
Recommended Posts
Leggy 0
I imported to ideamaker and the skirt is correct
in Cura it’s the same as above
Link to post
Share on other sites