If I use the volumetric RepRap profile with Cura 14.05rc2 a G11 is written directly after the ;SKIRT comment. As there is no G10 in my start.gcode, it results in a very ugly blob... :eek:
I'll check if I can handle it in Marlin, but IMHO the G11 is unnecessary at this point in the GCODE.
Yes, that doesn't sound correct. Most likely this is also added in the UM2 gcode, but, there it doesn't do much due to slight changes how the G10 and G11 are handled.
Recommended Posts
Dim3nsioneer 558
If I use the volumetric RepRap profile with Cura 14.05rc2 a G11 is written directly after the ;SKIRT comment. As there is no G10 in my start.gcode, it results in a very ugly blob... :eek:
I'll check if I can handle it in Marlin, but IMHO the G11 is unnecessary at this point in the GCODE.
Link to post
Share on other sites