Hey guys
Here some pictures of my toggle switch... you can clearly see where the long screw in the back "touches" it..
http://postimg.org/image/knwq5euxn/
And here some pictures of the scratches on the bottom of the Ultimaker where the adjustment screws of the buildplate hit it... (was like this already out of the box.. have no clue if this is normal):
http://postimg.org/image/6vbnrivt5/
http://postimg.org/image/wsgzv76s3/
Rgds
Robert
Recommended Posts
tesla 0
Hey guys
Just wanted to say that I have exactly the same issue with my Ultimaker 2.
It's really frustrating when you spend hours to calibrate it perfectly and the other day the prints look like crap and I'm sure than no one touched the printer (b'cause I'd kill em! ;-) ).
What I also noticed and do not know if it's normal that the print bed "hits" the bottom of the printer when it's
lowered to it's initial position. The two adjustment screws left also slight but noticeable scratches... normal?
However, I don't care about the scratches and the build plate hitting the bottom of the printer seems not to be the issue because all prints look perfect until you turn the printer off over night and want to use it the next day...
Thank you guys for your help and advice!
Rgds
Robert
Link to post
Share on other sites