Jump to content

No messages while message indicator shows 2


dirkels

Recommended Posts

Posted · No messages while message indicator shows 2

When I'm on the YouMagine site my message indicator (top right) shows that I have 2 messages. But when I click it to look at them there are none :-(

This is already like this for a long time, I discovered it just before a major update (the one with the beta site) and had hoped the update would reset the counter. I forgot it after that until now.

 

  • Link to post
    Share on other sites

    • 2 weeks later...
    Posted · No messages while message indicator shows 2

    This has been bugging me as well for a while...

    And speaking of messages, could we please get a change to the e-mail notification that goes out when someone posts a comment to include the actual message? It's really annoying to have to click the link, change over to the comments tab and then scroll down and find the new comment.

     

  • Link to post
    Share on other sites

    Posted · No messages while message indicator shows 2

    Not only that: Don't link to the notification itself, link to the comment. It is *extremely* annoying and userunfriendly that you have to log in to see a stupid comment.

     

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.7 stable released
        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 18 replies
      • S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
    ×
    ×
    • Create New...