Jump to content

Nozzle Temperature Decreases While Printing? :(


firatdede

Recommended Posts

Posted · Nozzle Temperature Decreases While Printing? :(

Hi friends,

When Ultimaker is printing it first sets the true 210 Celcius to temprature. But while printing temprature decreases and at below 200 degre.. 3d print starts to underextrusion because of higher viscosity.

Why it happens? It should stay at 210 degree or which degree that I set.. :(

Temperature drop

 

At image temperature drops to 195 degree.. and everything fails.. :/

 

  • Link to post
    Share on other sites

    Posted · Nozzle Temperature Decreases While Printing? :(

    I don't understand either of the last two suggestions. If the fans are causing a temp drop (which they surely must) then shouldn't the heater controller function compensate? At 210 it surely isn't already 100% on?

     

  • Link to post
    Share on other sites

    Posted · Nozzle Temperature Decreases While Printing? :(

    Yes problem is at fan I realised.. But before last update there were no problem. It was compensating itself. I reduced Fan speed %100 to %30. And now makes no problem. :)

    Thanks friends.

     

  • Link to post
    Share on other sites

    Posted · Nozzle Temperature Decreases While Printing? :(

    If the fan speed is set too high the heater can't keep up with the heat loss, particularly at higher print speeds, where it has to heat more plastic.

     

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
      • UltiMaker Cura 5.7 stable released
        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 26 replies
    ×
    ×
    • Create New...