Cura plugin , no infill from layer hight

[martin-schipper 0]

Hi,

is there ( i think not ) or is someone able to write a plugin

I would like to stop infill from a sertain layerhiight

im printing a covercap in flex fillement that has a center hang.

i whould like to support till the layer begins and continue without from there.

any sugestions

 

[pm_dude 27]

Use SwatAtZ. Create a first gcode with no infill. Save it and then change your setting and add the swatAtZ plugin. Provide the fullpath to that gcode including .gcode extension and specify the height at witch you want the swap to occur.

http://umforum.ultimaker.com/index.php?/topic/7290-new-plugin-swap-at-height/

[martin-schipper 0]

Tnx, i did that by hand now..

 

[gr5 2,204]

Doing by hand might not work right at the transition because the E values (extruder position) are cumulative. So at the point where you swap one gcode might say move E to position 1.345 meters and the other to 2.771 meters and it will try to extrude a meter of filament. Or it might unextrude/reverse a meter of filament.

 

[pm_dude 27]

add the code G92 E2.771 to reset extrusion at that value