Somebody tried this with 14.12 and the issue is still there. There seems to be a retract every "layer" change."
Somebody tried this with 14.12 and the issue is still there. There seems to be a retract every "layer" change."
Looking at the rebuilt version it in layer view you will see the toolpath switching from inner to outer shell. That vase is too thick to be printed in one pass with spiralize.
The solid version seems a better fit.
Simular issue discussed here
http://umforum.ultimaker.com/index.php?/topic/7754-skipping-corners-on-spiralize/?p=72378
Haven't tried with 14.12 to see if the same issues are there
Thanks for your answers.
I will try V14.12 to night and post the result.
I did one last night but with 14.07 and it was fine.
I can now confirm that V14.12 is fine.
Then this is most likely the result of the path order bug in 14.09, which is fixed in 14.12
Recommended Posts
pm_dude 27
Edit: Can you try with Cura 14.12? There have been issues with 14.09 but dont know of any with Spiralize
Link to post
Share on other sites