I'm very happy with the 14.12.1 and, finally, the temperature is really stable ... +/- 1° (... with 14.09 I had fluctuations of +/- 10°).
I read that few other people have had problems ... but I think due the heaterblock and the heater cartridge. You can find some discussions in "Cura" section on the forum
Guglielmo
Recommended Posts
bigmouse 6
I started with v14.09 so nothing to compare it with, upgraded to v14.12 and no obvious issues! Think the led lights behave slightly differently but printing seems fine, Also I think the default temps have been modified a bit too, but all good!
Link to post
Share on other sites