Can anyone slice this?

[LePaul 324]

I've tried a few times and Cura just sits there and doesn't build the print time on it

I don't know if its a lousy model (perhaps) or there's something wrong in Cura

http://www.thingiverse.com/thing:275096

There are two files, one says "repaired" but I can't get that one to do a print time/slice either

Thanks!

So say we all! =)

 

[axislab 8]

Loaded it in Cura, the status bar just hangs at the beginning. Doesn't even load the part for me either.

 

[pm_dude 27]

The part slice but it takes a while. Its still junk in the end and not printable.

The model is doubled, half is with inverted normals and the polygons are all exploded. In other word your into a lot of work to get that model to work properly.

If you look at it in XRay mode you will see that its almost all white. that mean that a lot of faces are overlapping.

 

[area0404 0]

Agree with the previous commenter. You seem to have duplicated the entire model. The first image (black and blue mix) means that there are overlapping surfaces.