GregValiant 1,304
@Apostoliszev was last here in September. I don't know if he got it working or not.
We can start over.
- Load a Benchy or calibration cube in Cura.
- Set Cura up to slice.
- Use the "File | Save Project" command to create a 3mf project file.
- Post the 3mf file here.
How many extruders are on your printer?
Edited by GregValiant
Recommended Posts
Top Posters In This Topic
23
14
8
7
Popular Days
May 4
10
Oct 22
7
May 25
6
May 26
6
Top Posters In This Topic
GregValiant 23 posts
Apostoliszev 14 posts
odonnse 8 posts
rebekah_harper 7 posts
Popular Days
May 4 2022
10 posts
Oct 22 2018
7 posts
May 25 2022
6 posts
May 26 2022
6 posts
Popular Posts
rebekah_harper
WanHao D4S: number of extruders: 2 filament size : 1.75mm X Y Z build volume: 220 140 150 origin offset : 110
CarloK
Why did you download v4.2.1? On the Wanhao website the most recent version is 4.7.1 Or, from the Ultimaker website the current version is 4.13.1
GregValiant
So there is an offset between the nozzles. That needs to be entered into Cura Machine Settings. Typically the T0/Extruder1 nozzle will have X=0 and Y=0 (no offset) and the T1 Extruder2 nozzle will h
Posted Images
PrintPrint32 0
Hi, I'm very new to 3d printing, especially with the Wanhao Duplicator 4. This thread helped me a lot to get started with Cura, but I'm stuck at the same point. The printer will start printing at the top right corner, without the extruder being above the bed. Did you find a solution?
Link to post
Share on other sites