I've taken more print heads apart than I care to count, but I never felt like I wanted to remove the head from the rods before doing it to be honest. But I can see how some people might find it more handy to do it this way for sure.
It's a very nice explanation of removing the rods however, I learned something there. My method has been a bit more brutish as I've clicked the rods out and then rotated the blocks 90 degrees so that the rods can then slide over them. The method described here is much better
Recommended Posts
gr5 2,224
I like it. I'm not sure if it's any easier loose like that but I would expect... probably. Maybe. I mean it's not hard to work on when held in place either. You can push the head around and it stays there. But I'll try the blizz method next time.![:)](//content.invisioncic.com/ultimake/emoticons/5a33abdf6d109_1f60acopy.png)
Link to post
Share on other sites