Jump to content

Bottom layer?


neo-ninja

Recommended Posts

Posted · Bottom layer?

Hi Guys,

Check this image. http://imgur.com/Lv6CODq

It is a best case scenario i am getting, the worst has small gaps. A few people in another post spotted the problem but that was when i was having issues not getting prints to stick. Now they are sticking perfectly.

They mentioned it could be a belt issue, but the belts feel pretty tight. How tight should they be? Could it be a bed issue. My prints now stick perfectly but should i try adjusting up the bed a fraction?

 

  • Link to post
    Share on other sites

    Posted · Bottom layer?

    OK great, I have tried changing to 0.2mm to see how that comes out.

    Potentially a silly question, but I have noticed when it is printing after a few layers it almost looks like the print is a bit too gooey and are not perfectly flat, so the head runs over them and then lays the plastic all fine but it almost seems to push it down and when the head moves off. the plastic pops up again. But it hasn't detatched from the glass at all.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
      • UltiMaker Cura 5.7 stable released
        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 26 replies
    ×
    ×
    • Create New...