My Ultimaker2 came in the mail today!

[craftee 19]

AHHH im so excited!!!

Here is my first print!!!

side note: everything went awesomely, but the SD card did not come with the robot stl file (no biggie). Only defect in the ultimaker2 that i found was the selection wheel. (there is something stuck inside that is causing it to scratch the wheel)

edit: after a bit of use the wheel works smoothly now

 

[valcrow 145]

Congrats! Looks great for first print!

Try without glue for PLA, just clean it well and then print directly on. It'll save you lots of time, hassle and cleanup.

 

[craftee 19]

Congrats! Looks great for first print!

Try without glue for PLA, just clean it well and then print directly on. It'll save you lots of time, hassle and cleanup.

 

Alright!

 

[izzy 33]

I use my wife's hairspray(she's brought me my own for the printer now, not for me im solar powered) works well for PLA ranges

[izzy 33]

Have a look on YouMagine at Roberts feeder, well worth making as your 1st upgrade,

[craftee 19]

Have a look on YouMagine at Roberts feeder, well worth making as your 1st upgrade,

 

thanks for the heads up!

 

[skint 61]

Welcome to the community and congrats on your purchase Great first print!

 

[craftee 19]

Welcome to the community and congrats on your purchase Great first print!

 

Thanks! i was surprised at how the first print turned out

 

[personal-drones 44]

Welcome to the club To print PLA use 55°C and nothing on the plate, it is not needed.

 

[craftee 19]

Welcome to the club To print PLA use 55°C and nothing on the plate, it is not needed.

 

gotcha

 

[craftee 19]

New prints!

 

[tsagos 8]

Keep in mind that small parts are harder to print!

Go bigger m8!