Ghene

Anyone tried printing with the rPET filament? Does it even work with Ultimaker?

I am trying to print a vase from a solid file. My infill is set to zero as well as the top layer. How can I make the inside of the vase smooth instead of having thin webs?

that is so cool!. I'm digging out my tulle 🙂

It looks like he is using Tulle fabric.

Yes, ity is now.

wow! that looks good! I haven't had the time to try fabric printing yet as was busy fulfilling orders.

I need that 😛 Those prime blobs that get drag around are the bane of my prints and printcore.

Thank you.

Nothing changed. Printcore 2 is a AA0.25 but Printcore 1 is AA0.4

After the recent update, only Fine protected profile is left on my Cura. Any idea how to fix this?

Fixed it, machine is now working with backup printcore. I do not have the luxury of sending my machine up to be fixed when the problem is just the printcore specially with my fundraising for ZSL in full swing. The filament oozed up and into there and hardened like a rock...Since Printcore is already non-responsive (tried the atomic method shown in the support pages first), I had to use my heat gun to slowly melt and pull the filament off bit by painful little bit. Last bit was that part that's blocking the printcore into the printhead. I tried prying the filament off gently, but instead, the bottom bit of the printcore came off. To not cause damage, I had to open up the print head to reach it, put it back together (less a screw since one escaped) 😞 I need a replacement printcore and short bolt pretty please (for the printhead) 😛

The regular rPLA filaments prints well just like the others. The cosmic filaments have small particles in it sometime causing the printcore to clog up, need a fine needle to clear it up. So beware. Prints well though and it hardened nicely. Sorry, test piece is the varse for their #cosmicchallenge. I wanted to try winning some freebies 😛

So my UM3e decided to play up again. The print failed and became a blob around Printcore 1 again. Print core 1 stopped responding, I tried turning up the temperature to melt some of the filament but alas, it stays cold and gives me that printcore error. Managed to take Printcore 2 off by increasing the temperature until the filament that's blocking it is melted. Not so perfect timing... Christmas shopping period is here 😕 I need to replenish my stock.

The Patreon is a good platform but recent changes in fees resulted in less sponsors.

Try etsy or folksy.