I am really baffled, after using pronterface to move around the axes everything seems fine except moving the printhead 60 mm to the right does not centre it( this is the value half the width of the print bed). I have ensured the cables attached to the motor and xy stops is not pinched anywhere.
Any Ideas would be greatly appreciated.
Recommended Posts
Speedy 0
I tried printing a 110mm wide rectangle and as expected the printer printed it too far to the left resulting in some of it printing off the build plate. It seems that the machine does not know exactly where the print head is. I have checked the plugs of all the sensors into the arduino.
Thanks in Advance to the awesome community
Speedy.
Link to post
Share on other sites