With the stock heat block it works perfectly?
Maybe your temp sensor is dead?
I guess you tried with various filaments? What is the brand of the filament?
On your picture it looks more like over-extrusion but i might be wrong (hard to see)
I don't think it's the temperature sensor, because I've switched the ollson block for the original nozzle before. I DID get a heater error when I tried an extrusion test, but after that I move the fanshroud around a bit to make sure that it doesn't touch the nozzle anywhere.
I didn't get the error with the print in the picture so I guess that's okay.
I've been experementing with REAL pla (yes, REAL is the actual brand) now, got a spool of black and one of blue.
It's indeed kinda difficult to see what happens on the print because it's black, but it shows underextruded layers and layers being inregular.
I always print at 210C with a speed of 30mm/s
Recommended Posts
DidierKlein 729
With the stock heat block it works perfectly?
Maybe your temp sensor is dead?
I guess you tried with various filaments? What is the brand of the filament?
On your picture it looks more like over-extrusion but i might be wrong (hard to see)
Link to post
Share on other sites