I use a 0.3mm first layer as well.
Would it help to have a slower print speed for the first layer?
This problem on the bottom layer is my biggest problem at the moment. It takes quite a bit of work to sand away the grooves. The top layer is fine.
To me it looks like the platform was a little to close to the nozzle. It starts putting too much material and then the material start to curl up on the sides.
It is not so easy to have the platform just right. That is why I use 0.3mm first layer but even then this might happen.
Recommended Posts
zoev89 73
To me it looks like the platform was a little to close to the nozzle. It starts putting too much material and then the material start to curl up on the sides.
It is not so easy to have the platform just right. That is why I use 0.3mm first layer but even then this might happen.
Link to post
Share on other sites