Fans turn on despite being unchecked in Cura 2.1.2

[LePaul 328]

Is this just a bug I'm experiencing or a known issue?

Doing some nGen test prints and they advised no fans.

Unchecked the Enable Cooling Fans and saved to SD card. Ran the print...fans turned on I was able to shut them off via the Ulticontroller but, of course, it should work in Cura

[DaHai8 74]

I tried it with my RepRap style Printer, and it omitted the M106 command from the gcode when I unchecked that box.

So it could be machine/json file dependent.

Also, look through that fan-off gcode for M106 to ensure its in there or not.

Also, does the fan turn on immediately or after printing the first few layers?

P.S. I just tested it with the Ultimaker Original printer profile and the M106 255 is on ;Layer:1 with the Fan enabled and nowhere in the gcode when I uncheck the 'Enable Cooling Fans' box. Let us know what you find.

Edited July 23, 2016 by Guest

[LePaul 328]

My fans turned on when it hit layer 0.5

[Dim3nsioneer 557]

Disabling fans in Cura 2.1.2 works fine on my UM2.

[LePaul 328]

Not one mine....tried again.

[Dim3nsioneer 557]

But they don't run on the first layer, do they?

[LePaul 328]

No, not the first few layers...which is expected behavior

But turning on at layer 0.5 when unchecked in Cura...shouldn't do that

[gr5 2,206]

@nallath - I think this is a simple cura 2.1.2 bug that happens only with UMO (non ultigcode). Edited July 25, 2016 by Guest

[LePaul 328]

Only with UMO?

Well...Mom always said I was special