I only use Race nozzles they just work extremely well for me, I have not used an old RSB Jet for maybe six months.
The list of abrasive materials is longer than you might think, it includes Bronzefil (any metals I think) also Woodfil and 'glow in the dark' too. I have several stainless nozzles but the Sapphire or Ruby is much better IMO
- 1
Recommended Posts
stu_le_brew 42
In my opinion the Matchless nozzles are a useful improvement to printing they allow you to print cooler and faster, my current favourite is a 0.6mm which allow me to print (using HDglass from Form Futura) at 50mm/s with layer height 0.25 at a temp of 208-210 With the older brass nozzles I was printing at a temp of 218) the results are of a very impressive quality. Its far better that the original UM 0.4 nozzle printing at half the speed.
I have not used the old brass nozzles since buying the Matchless nozzles
So Yes I would recommend them, I am less enthusiastic about the Stainless nozzles as heat transfer is slower so you have to slow down the print speed. The only reason to use a Stainless nozzle is with hard materials but the Sapphire and Ruby nozzles achieve the same result without significant reduction in print speed.
I should say I have no financial relation ship with @swordriff at 3DSolex, except I am a fan of his products
Edited by GuestLink to post
Share on other sites
fergazz 60
Thank you for this consideration
Which Mathless nozzle you are refering to... Race or RBS Jet? Anyone have a side by side comparition about those?
Is there an alternative beetwin Stainless Steel and Sapphire/Ruby nozzles? I'm looking for a nozzle for Bronzefill, and maybe for other abrasive filaments but I will not be a hard level abrasive printer, I suppose
Edited by GuestLink to post
Share on other sites