14 hours ago, Smithy said:But anyway, a nice color 🙂
yeah, it is a nice color... I like it!! 😀
Definitly it's not shiny. Less vivid than this photo... slightly white, looks like it was sanded
14 hours ago, Smithy said:But anyway, a nice color 🙂
yeah, it is a nice color... I like it!! 😀
Definitly it's not shiny. Less vivid than this photo... slightly white, looks like it was sanded
I got some of the matte grey again and i face the same problem i had with my old 1.75mm printers when i tired it and that is it sticks far to well to the glass and you end up 1) breaking the part getting them all or 2) clip the glass.
Have people been using normal PLA settings with it? I have my initial layer height set at 0.2mm i think i might try 0.15 but i worry about chipping the glass keeping on using it.
You could try using a raft?
Also it's important to let the print cool. I run mine under water and they release ok.
13 hours ago, ScanHD said:You could try using a raft?
Also it's important to let the print cool. I run mine under water and they release ok.
I always let my prints cool 🙂 it just sticks way to good to the glass, i'll back off the first layer so its pushed down less.
Recommended Posts
Smithy 1,146
But anyway, a nice color 🙂
Link to post
Share on other sites