-
Our picks
-
UltiMaker Cura 5.4 stable released
ArunC posted a topic in UltiMaker Cura,
The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!-
-
- 58 replies
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Picked By
MariMakes, -
-
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Recommended Posts
gr5 2,071
This is normal. PLA will stick on top of PVA. But PVA only sticks to PVA. It sounds strange but it's true.
The fix is to use horizontal expansion - it's a feature of cura - it's not working for you for some reason. Try increasing support horizontal expansion to maybe 10mm to see if that makes it so the pva is connected all the way down.
By the way this print doesn't appear to need any support so you could just disable support.
Link to post
Share on other sites