TPU Print with 300mm/s Travelspeed?

[PhilDesign 2]

I want to print TPU without many string as possible with my UMO+.

Can I put the Travelspeed up to 300mm/s or is that not good for the printer because it is to fast?

May I use retraction? I use TPU A95 which is quit hard for a TPU.

 

Thanks for any answer 

[fbrc8-erin 267]

With TPU you generally want to avoid retraction if possible, but I think increasing the travel speed should be fine, though I usually only go up to about 250 for travel speed.