PP not in Ultimaker 2+ extended

[Jeremi 4]

I'm about to change material on my ultimaker 2+ extended but just as i'm putting the material in the interface I see no option for PP. On this page https://ultimaker.com/en/products/ultimaker-2-plus  it's says it's not optimized for it and on this page https://ultimaker.com/en/resources/49799-material-compatibility?utm_source=cura&utm_medium=software&utm_campaign=resources it's says that it can ???? My firmware is up to date also. Do I choose a random material and change it right before printing?

[fbrc8-erin 287]

Did you do a factory reset after updating your firmware? Sometimes new profiles don't show up after a firmware update unless you factory reset the printer. 

PP should be fine for a UM2X+. It uses the same feeder as the UM3. 

[Jeremi 4]

ok thanks @fbrc8-erin I did not do a factory reset i'll try that. Edit: it worked!

Edited June 6, 2018 by Jeremi

[fbrc8-erin 287]

Glad it worked! Definitely always do a factory reset after a firmware update; it's the best way to make sure all the changes really go through.