I wouldn't go lower than 3 seconds. It takes about that long just to get down to 60C and PLA is like putty/clay/plasticine at that temperature. at 50C PLA is finally hard like pastic.
-
Our picks
-
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications-
-
- 3 replies
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Picked By
MariMakes, -
-
UltiMaker Cura 5.7 stable released
ArunC posted a topic in UltiMaker Cura,
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
-
-
- 26 replies
Picked By
MariMakes, -
-
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Recommended Posts
Dim3nsioneer 557
It's maybe the minimum layer time that slows it down. Do you use the spiralize function?
Link to post
Share on other sites
psykat 0
Thank for your reply.
Yes. I used the spiralize function - but without that also it seems to be slow compared to set speed.
How to decide on the minimum layer time?
Link to post
Share on other sites