Breakaway Support is good, but not possible for all objects.
But PVA is much more expensive than BreakAway. Here in Europe, a spool of UM PVA 705g costs 100€ and BreakAway is about 65€.- The PVA spools which cost only 50€, have only 350g, so be careful 🙂
There are also possibilities, to mix PLA and Breakaway for support to save costs. So you can print the Support with PLA and only the support roof with the other extruder with Breakaway loaded.
Recommended Posts
rcfocus 0
The failure rate of PVA is too high so that I decide to give up PVA. Now I use breakaway filament for support. The result is so good. The bad news is the price is much more expensive than PVA.
Link to post
Share on other sites