UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Thanks guys. I did see the adhesion sheets but could not remember where. I have a part that I want to print from nylon and PC and then test to see which one is better for the application.
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
Recommended Posts
SandervG 1,521
Hi, have you visited this page already? It may contain all the tips you're looking for!
Link to post
Share on other sites
RudydG 62
Personaly, i get the best results with dymafix. Also on um5.
Just don’t use support that requires cooling, you will get into trouble. No fans!
Link to post
Share on other sites
Kevinrhug 0
Thanks guys. I did see the adhesion sheets but could not remember where. I have a part that I want to print from nylon and PC and then test to see which one is better for the application.
Link to post
Share on other sites