I had to file the slots out more on the X-axis motor mount so that the short belt could be tightened. That helped a lot with similar problems to yours.
Also, you can try increasing the filament flow % from 100% to 110%, or use a smaller filament diameter setting than 3.00mm (try 2.85mm). Measuring the filament diameter in one spot is not always accurate since some filament might vary a lot.
Recommended Posts
owen 19
Not sure Nicolinux but maybe if you try raising the temperature a bit, that would increase extrusion a bit (make wider tracks) and make it stickier
Link to post
Share on other sites