Jump to content

Recommended Posts

Posted · Why does my Ultimaker S5 start extruding in the air?

Hi!

 

My Ultimaker S5 suddenly started extruding in the left corner and i pulling it back on my print - sometimes it result in a unusable print...

 

It does it the same place, layer by layer.

 

There is nothing there, in my Cura setup.

I have set my UMS5 back to factory settings, but it did not help.

 

I have attached pictures of the line that goes trough my print (is .

 

Have anybody else tried this? I cannot find anything similar.

 

Thank you!

 

/Alek

 

UMS5 Problem 5.jpg

UMS5 Problem 4.jpg

UMS5 Problem 3.jpg

UMS5 Problem 2.jpg

UMS5 Problem.jpg

UMS5 Problem 7.jpg

UMS5 Problem 6.jpg

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.9 stable released!
        Here comes Cura 5.9 and in this stable release we have lots of material and printer profiles for UltiMaker printers, including the newly released Sketch Sprint. Additionally, scarf seams have been introduced alongside even more print settings and improvements.  Check out the rest of this article to find out the details on all of that and more
          • Like
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Heart
          • Thanks
          • Like
        • 7 replies
    ×
    ×
    • Create New...