Jump to content

My printer can't print beatifully on circular areas


Recommended Posts

Posted · My printer can't print beatifully on circular areas

I would first check the hardware, tighten belt, pulleys, and so on. Check if the head can mode smoothly when the steppers are disabled and you move it by hand. Maybe you need some oil on the rods, or wherever your printer need it.

 

Then check the slicing settings, print slow < 40mm/sec and check the result again. Maybe you print a way too fast and your printer cannot handle the speed.

  • Link to post
    Share on other sites

    Posted · My printer can't print beatifully on circular areas

    A few weeks before it can print in 60 mm/s but what happened I don't know it can't now I tightened belts but again this result but I didn't add oil also I don't understand where I have to oil. Thank for your advice I will try them and I will reply after try them .

  • Link to post
    Share on other sites

    Posted · My printer can't print beatifully on circular areas

    I can mode steppers smoothly I check them and print at 30mm/s but nothing changed the same result again. 😞

     

  • Link to post
    Share on other sites

    Posted · My printer can't print beatifully on circular areas

    It is hard to give more advises, I don't know your printer, but it is definitely a hardware problem.

    General it is often loose belts, bad bearings, dry axles (oil), some play in the mechanics, head not stable enough and can vibrate easily, print too fast, extrusion problem (nozzle, feeder), bad cheap filament, .......

     

    So I can give you only general advices, most users here are using Ultimaker printers, so a chance to find someone who can lead you to the problem directly because he know the printer is small.

  • Link to post
    Share on other sites

    Posted · My printer can't print beatifully on circular areas

    I've solved the problem It cause from software last version of marlin tarantula 2.0x is problem for tevo tarantula . I'm going to bring older version of marlin tarantula 2.0 .Thank you for all your replies.

    MarlinTarantula-EasyConfig-2.0.x older version.zip

  • Link to post
    Share on other sites

    Posted · My printer can't print beatifully on circular areas

    I'm glad you found a solution. 🙂 

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
      • UltiMaker Cura 5.7 stable released
        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 26 replies
    ×
    ×
    • Create New...