No, this is not a concern. Is that it is technically impossible to adjust ... So printing!
To libere the head, I manually lower the glass on the setting. The setting is as impossible!
Ultimately, if there existed a way to move the head a little, a one hand so to clear and settle the bed, it would pose no more problems.
Recommended Posts
IRobertI 521
I'm not sure if this has been fixed in firmware yet as I haven't updated in a while, you can try updating the firmware first and see if that stops this from happening.
If it doesn't you can swing the clip out and bend it down a bit with a pair of pliers to keep it from hitting the fan shroud (I did this on my machine). Or you can try to swing it out a bit until it clears the head but still keeps the glass in place. I noticed that if you swing the clip out completely the glass plate raises up slightly and screws up your bed leveling that way instead.
Link to post
Share on other sites