Slicing problem Cura

[TiseHe2 0]

Hi, I use a Creality ender 3 and in Cura when I slice a model only the top layer is sliced. I tried to move the sliders at the bottom and on the right, Re-install Cura in older versions.

It affect all stl that I import in cura and I didn't change settings in Cura btw.

 

Thanks for help

[TiseHe2 0]

If you have in idea how I can solve that that will help a lot.

[GregValiant 1,273]

It says it will take 2.5 hours to print.  That is more than 1 layer.  It might just be a preview problem.  When you generate a gcode - how big is the file?  If you open the gcode file in Notepad and search for "Layer" it should start at layer:0 and continue to the top layer.

[TiseHe2 0]

I know it's more but when I print it only make the last layer at the bottom of my bed

The file weigh 7,10Mo and the layer start at 0 so i don't know where the problem came from

there is the g-code file plus the stl

CE3_3d_benchy_quick_print.gcode 3d_benchy_quick_print.stl

[GregValiant 1,273]

Did a warning come up that the model is not "watertight"?  It did for me.  That's a bad model.

 

Try this one.

3DBenchy.stl

[GregValiant 1,273]

When I open your gcode file in Cura it looks OK.  Going through the file it looks OK there too.  I don't see any reason why it would not print.

There are purge lines that should be on the left side of your bed.  Are they printing?  Is the skirt printing?