The LED strips do not adhere very well, the problem I have already discovered during my first print tests. Currently I check before each use of the machine the correct fit of these strips. But it is annoying and therefore quickly a workable solution should be found. Has anybody a good idea?
Maybe you could even use special transparent adhesive tape with sufficient width.
Markus
Recommended Posts
ian 32
i think they are testing much stronger glues for this... also small screws to bolt the LED strips into place.. That might be even better.
I noticed with my UM2.. that they used very aggressive strong glue and the glue had burned quite a large whole into the back of the front plate.. so not the best solution.
Ian
Link to post
Share on other sites