UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
The two cores won't mechanically ever be at the same height. And if you were to do this the heads would have to be within about 0.05mm at the same height. Not 0.5mm, not 0.1mm but 0.05mm would be about the maximum you could print with different heights.
The piece of metal in the base of the print head is different for the left and right core. There is just no way to adjust one core vertically (to that kind of precision) without affecting the other core. There just isn't a way the hardware can do this even with some simple modifications.
And then you would have a software problem as for the S5 you have the T0 command (tool zero) and T1 command (switch to tool 1). When you issue those it swaps "tools" (cores). There is no way to tell both extruders to move at the same time without modifying the firmware. After a T0 command, moving the extruder only moves the left extruder. After a T1 command, using gcodes to move the extruder only moves the right extruder.
Instead, to speed things up, consider getting some smaller, cheaper printers to supplement your S5. Smaller printers tend to print with more precision. I have 3 um2go printers that cost much less than half the cost of a single S5 (although I modified them to have the olsson block and the heated bed).
Link to post
Share on other sites
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
gr5 2,224
The two cores won't mechanically ever be at the same height. And if you were to do this the heads would have to be within about 0.05mm at the same height. Not 0.5mm, not 0.1mm but 0.05mm would be about the maximum you could print with different heights.
The piece of metal in the base of the print head is different for the left and right core. There is just no way to adjust one core vertically (to that kind of precision) without affecting the other core. There just isn't a way the hardware can do this even with some simple modifications.
And then you would have a software problem as for the S5 you have the T0 command (tool zero) and T1 command (switch to tool 1). When you issue those it swaps "tools" (cores). There is no way to tell both extruders to move at the same time without modifying the firmware. After a T0 command, moving the extruder only moves the left extruder. After a T1 command, using gcodes to move the extruder only moves the right extruder.
Instead, to speed things up, consider getting some smaller, cheaper printers to supplement your S5. Smaller printers tend to print with more precision. I have 3 um2go printers that cost much less than half the cost of a single S5 (although I modified them to have the olsson block and the heated bed).
Link to post
Share on other sites