Spiralize, but with lined bottom layers?

[sean67854 0]

In Cura 4, when I printed bowls, cups, vases, etc in spiralize mode, the bottom layers would have circled borders with lines in the middle.  This was great and always resulted in a excellent interior bottom surface.  

 

Now in Cura 5, when spiralize is selected, the bottom layers are printed completely in a circular pattern which is not nearly as smooth and results in a blob in the middle.

 

Is there any way in Cura 5 to force lines for the bottom layers when spiralizing?

 

I'm using an Anycubic Vyper and i've attached the profile.

Cura 5 PLA spiral .8 width.curaprofile

[GregValiant 1,320]

That's the way it works in 5.0.  Maybe @nallath can comment on the change and why it was made?

[nallath 1,123]

It was already reported by others. We're currently looking into it!

[Bpositivedotdk 0]

Yes, this is quite annoying - still happening in 5.1 beta!

[LRUK 0]

This issue is still present in the live release of 5.1. Any idea if/when this will be addressed? Until it is, Cura 5.1 is not a great option for spiralize/vase mode prints.

[MariMakes 199]

Thanks for raising this, we've been getting multiple reports on this.

I'll raise it with the team again. 

[GregValiant 1,320]

Hello all.

There have been several reports (complaints really) on GitHub (#12862 for one) and it is alleged to be on the backlog as Cura-7926.